Route QLC+ to broadcast an Art-Net feed to your local loopback IP address ( 127.0.0.1 ).
| Driver Source | Type | Windows 10 2021 Compatibility | Notes | |---------------|------|-------------------------------|-------| | Vendor CD (generic) | Custom INF + sys | Limited (often unsigned, 32-bit only) | Usually fails on 64-bit Windows 10 unless test mode enabled | | libusb / Zadig | Generic WinUSB driver | – works | Converts device to WinUSB; used by QLC+, DMXControl, Freestyler | | FTDI VCP (incorrectly assigned) | Virtual COM port | No – wrong protocol | Does not generate DMX timing | | OpenDMX (Enttec Open DMX) driver | Custom | Yes (with INF modification) | Requires editing Enttec driver to match CYL6602 VID/PID | cyl6602 usbdmx512 driver windows 10 2021
Once Device Manager shows the device cleanly assigned to a specific port (e.g., COM3 ), you must map it within your DMX control software. For QLC+ (QLC Plus) Route QLC+ to broadcast an Art-Net feed to
: Compatible with Windows 10 (32-bit and 64-bit). This public link is valid for 7 days
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. cyl-6602 working with Qlc 4 - Q Light Controller+
May require a specific plugin or Art-Net loopback (QLC+ -> Art-Net 127.0.0.1 -> FreeStyler). Compatible