Iprog Rework 〈99% RELIABLE〉

: Replace the existing resistors at the designated locations on the mainboard. Resistor 1 (Green dot location) : Must be 4.7k Ohm . Resistor 2 (Blue dot location) : Must be 51k Ohm .

Disclaimer: Modifying electronic devices voids warranties and may violate local laws regarding immobilizer circumvention. Always ensure you have legal permission to access vehicle electronics. The author assumes no liability for damaged ECUs or legal consequences. iprog rework

Replace the current sense resistors with 0.22 Ohm (or three 1 Ohm resistors in parallel) . : Replace the existing resistors at the designated

via USB (or external 5V on the programmer header). and R57 on mainstream schematics).

Locate the hardware feedback network near the primary microcontroller (usually labeled R19, R49, R54, and R57 on mainstream schematics).