For Arduino Datasheet ((hot)): Hw 130 Motor Control Shield

Connect your Arduino to your computer via USB or a 9V barrel jack adapter to power the logic gates.

Proper power management is the most important factor when working with the HW-130 shield. Misconfiguring the power supply can destroy your Arduino or cause intermittent resets. The Power Jumper (PWR) hw 130 motor control shield for arduino datasheet

Unlike some generic L298N modules, the HW 130 reserves pins 3 and 11 for PWM, making it ideal for speed control. Do not use these pins for other sensors. Connect your Arduino to your computer via USB

is a highly versatile, budget-friendly hardware expansion board designed to drive inductive loads like DC motors, stepper motors, and servos. It is widely used in hobbyist robotics, automated CNC prototypes, and DIY mobile platforms. Structurally, it is a fully layout-compatible open-source clone of the classic . The Power Jumper (PWR) Unlike some generic L298N

Connect your motor power supply (4.5V–25V) to the screw terminals. Pay close attention to polarity (+ and -).

The library also supports steppers. To run a stepper on M1 & M2, you would use: