V2000-c Rfid Access Control User Manual Jun 2026

Connect the wire of the V2000-C directly to the Positive (+) terminal of the Magnetic Lock. Configuration B: Fail-Secure Lock (e.g., Electric Strike) An electric strike requires power only when unlocking.

To help clarify your specific hardware setup, please let me know: V2000-c Rfid Access Control User Manual

Use the provided security screwdriver to remove the back housing from the keypad. Connect the wire of the V2000-C directly to

Note: Verify label on your unit for exact terminal names and polarity. V2000-c Rfid Access Control User Manual

A: Check the J1 relay jumper settings (Part III). Ensure the jumper is set to NO if you are using an electric strike lock that requires a momentary closed circuit.

[Card + PIN mode: User must both present a registered card AND enter a 6-digit PIN]